White sponge. Homemade custard mousse ( Paukščių pienas). Chocolate glaze and ready to roll icing flowers.

White sponge with fresh whipped cream+soft cheese+mandarines+poppy seeds. Fresh whipped cream and ready to roll icing decorations.

White sponge. Fresh whipped cream+peache yogurt+peaches. Ready to roll icing decorations.

Sponge fingers, fresh whipped cream+mascarpone cheese. Coffee flavor.

So I’ve got the following error on Cisco UCS IOmodule it came out of nowhere.

left IOM 4/1 (A) POST failure
Code: F0481

So the fix could be very simple try reseating or resetting the IOmodule that is giving the problem.
Before you attempt to do that make sure that you the other IOmodule in the Chassis is working fine and all the blades in the chassis have other path available when the IOmodule is reseated. If you have only one IOmodule then you would need to power down the blades first.

Here I’ll show how to reset IOmodule from UCSM.

First select the IOmodule that is giving problems and click Reset IO Module

You’ll be prompted to confirm

You should see now that IOmodule is not reachable and one path for Chassis is down.
Also Critical errors and Warnings will be logged.

Wait for the IOmodule to comeback and the errors to clear.

If all is clear then monitor this module for couple weeks or so. If the same Error appears on IOmodule then call Cisco support to get the module replaced. I’ve seen where the error would reappear after 2-7 days. In that case call Cisco support to get IOmodule replaced.

First throws of my new toy 🙂

Hi, I bought a DLG glider named BLASTER 2. It is a second handed glider, because the new ones are quite expensive. While waiting for my plane I started researching how to set my remote right. And I faced a problem with the flying mode switch…
I looked everywhere, but I didn’t found any useful information, but I managed to configure it by my self.

E switch on Futaba T7C
(ail) to 1 at the receiver ail 2 to 6

press Mode select D/R, EXP.
D/R, EXP SW>E
CH>1-AIL (-)
D/R> 100%
Exp> + 0% (here you can chose the sensitivity of your model)

next press END and MODE (Advanced menu)
select FLAPRN
FLAPRN >ON
DIFF> +6 (select the difference between the ail movement)
AIL-2>CH6

END

select P-MIX1

P-MIX1 ON also can be OFF,depends on the switch position
MAS>OFS
SLV>CH1
SW>E (wanted position)

back using select (cursos)
P-MIX1 OFS->1

RT>+ 55% the amount is your choice. when switching E you should see ONE Aileron moving

END, P-MIX2

P-MIX2 >ON or OFF
MAS>OFS
SLV>CH6
SW>E (same position as in mix 1)

back to
P-MIX2 OFS->6

RT> – 44% (select the amount)

Video:

So here is the photos of the finished plane. RTF weight is ~600 g

So this is the video of the first flight! it was quite windy and COLD! but it flies perfectly! but when I landed my ailerons broke off the tape (I suppose it is because of the cold)